Hello! My name is Bill Hagen. I have worked in the medical device industry for over 25 years as a design, R&D, molding/tooling engineer. I have gained a wealth of knowledge and experience in all aspects of plastic part design as well injection mold development and validation. I am a certified Master Molder 2 and have subject matter expertise in all aspects of plastic part design, mold design and development as well as injection mold process development and validation. I am also experienced with complex molds such as insert/over-molds, 2-shot multi-shot molds, difficult resins as well as cavity pressure sensors and part containment good/bad part sorting strategies. I also have experience with plastic assembly techniques, test fixtures, test plans and metrology.
I can use my knowledge and experience on your project or problems in a cost effective manner by allowing you to only pay for the services you need versus a full time consultant.